[Pre order]Hummingbird 200 ESC RaceSpec 80A 3-6S AM32 20×20 Designed for Extreme Racers

Hummingbird 200 ESC RaceSpec 80A 3-6S AM32 20×20 Design for Extreme Racer The Hummingbird 200 RaceSpec 4in1 ESC is a compact, race-tuned 20×20 ESC engineered for the brutal demands of 5 FPV racing. Developed in collaboration with pro pilot Kyle Buell (Twidgit), it directly addresses real pain points racers faceoverheating MOSFETs, pad failures after crashes, and oversized ESCs that dont fit low-profile frames. With 80A continuous current for 10 seconds per channel and 100A burst for 3 seconds, this ESC delivers the raw, reliable performance needed to win heats. It supports 36S LiPo input, making it perfect for todays high-throttle 5 race setups. The board is built on a 6-layer PCB with 3oz copper, blind vias, and a gold-plated finish, ensuring excellent thermal handling and structural durability. Two onboard 400W TVS diodes provide effective surge protection without requiring external components, keeping your build clean and protected. A standout feature is the 3D motor pad structureeach motor pad wraps around the top, bottom, and side of the board. When properly soldered, this creates a grip-like bond thats far more resistant to pad delamination, even after hard crashes or broken arms. Powered by an AT32F421 MCU with integrated gate driver, the ESC runs smooth, responsive AM32 firmware, giving racers reliable performance and open-source configurability in a compact 20×20 footprint. Whether youre chasing podiums or rebuilding mid-event, the Hummingbird 200 RaceSpec ESC is built to handle it allwith the performance you need and the reliability you can trust. Spec: Input Voltage: 36S LiPo Continuous Current for 10 seconds: 80A per channel Burst Current: 100A (up to 3 seconds) Firmware: AM32 MCU: AT32F421 with built-in gate driver TVS Protection: 2x onboard TVS diodes (400W each) Motor Pads: 3D structure top / bottom / side solderable PCB: 6-layer, 3oz copper, blind vias, gold-plated finish Signal Connector: 8-pin JST-SH 1.0 Power Pads: Reinforced BAT / BAT for high-current builds Mounting Pattern: 20x20mm (M3 holes) Dimensions: 35 x 45 mm (including solder pads) Weight: ~13.9g (without wires or capacitors) Use Case: 5 FPV racing, optimized for extreme reliability Comes with Nano Coating User Guide:LinkDownload 3D Design Files (STEP):Link Wire Diagram: Include:1x Hummingbird 200 ESC RaceSpec 80A 3-6S AM32 20×20 Design for Extreme Racer5x Grommet1x 14awg Power cable1x XT60 Plug1x 8Pin 100mm Silicone Cable for FC Connection1x 1000uf Capacitor2x Tiny heat shrink for capacitor